Genuine Bush Logik Russell Hobbs Tumble Dryer Door Striker Pin 301160760433
Genuine Bush Logik Russell Hobbs Tumble Dryer Door Striker Pin 301160760433
If your tumble dryer door will not stay closed, or the dryer will not start even though the door is shut, the plastic striker pin on the door may be cracked or worn. This is the genuine door striker pin, part number 301160760433, for selected Bush, Logik, Russell Hobbs, Montpellier and Amica vented tumble dryers. Fitting a new pin lets the door latch securely and press the door switch again so the dryer can run.
Product Details
- Product Type: Tumble Dryer Door Striker Pin (door catch pin)
- Main Part Number / MPN: 301160760433
- Alternative / Manufacturer References: 12138200000114
- Part Category: Laundry - Tumble Dryer Door Parts
- Appliance Types: Vented Tumble Dryers
- Brand Compatibility: Selected Bush, Logik, Russell Hobbs, Montpellier and Amica models
- Material / Colour: White plastic
- Approximate Size: 39 x 38 mm, fixing holes 19 mm apart (supplier data)
- Part Type: Genuine Original Part
- Pack Includes: 1 x door striker pin
What This Part Does
The striker pin is the plastic hook on the inside of the dryer door. When you close the door it pushes into the catch and door switch in the cabinet, holding the door shut and telling the dryer it is safe to run. Because it takes a knock every time the door closes, the pin can crack, wear or snap off, especially if the door is slammed.
Common Fault Symptoms
- The door will not stay shut or springs back open
- The dryer will not start because the door is not detected as closed
- The door opens part way through a cycle
- The pin on the door is visibly cracked, loose or missing
Known Compatible Brands & Models
View compatibility information
This pin is shared by vented tumble dryers built by the same manufacturer and sold under several brands. The models below are listed against part 301160760433 and its alternative reference 12138200000114. The model number is usually on a label inside the door opening.
Compatible Models
- Bush: TDV6B, TDV6S, TDV6W, V6SDB, V6SDS, V6SDW, V7SDB, V7SDS, V7SDW
- Logik: LVD6W13, LVD7W15, LVD7W18
- Russell Hobbs: RHVTD300, RH7VTD50
- Montpellier: MTD30P, MTDAD3P, MVSD7W
- Amica: ADV7CLCW, WTA14304W, WTA14305W
Compatible Brands
- Bush
- Logik
- Russell Hobbs
- Montpellier
- Amica
Please check your appliance model number and compare the original part before ordering.
Repair Difficulty
Easy. The pin fits to the inner door with two small screws. Remove the old pin, fit the new one in the same position and tighten the screws. It usually takes a few minutes.
Typical Tools Required
- Small screwdriver (Phillips or Torx, depending on model)
Description
A broken door striker pin is a common reason a tumble dryer refuses to start. The motor and heater may be fine, but without the pin engaging the catch and door switch the dryer will not run. Replacing this small part is a quick and inexpensive way to get the dryer back in use.
This is the genuine part 301160760433, also referenced as 12138200000114. Check the pin on your door and your model number against the list above before ordering, or send us your model number and we will check it for you.
Unplug the tumble dryer before working on the door. After fitting, check that the door closes firmly and that the dryer only starts with the door shut.
Brand names, model numbers and part numbers are used for identification and compatibility guidance only. This part should be checked against the original appliance model number and existing part before ordering.
Replacing a faulty appliance part can help extend the life of your appliance and reduce unnecessary waste.
Compatible Models
MPN Number
301160760433