Genuine Midea Dishwasher Heating Element in Pump Body 1800W for Kenwood Logik 17476000007431

Genuine Midea Dishwasher Heating Element in Pump Body 1800W for Kenwood Logik 17476000007431

Bring hot, clean washes back to your dishwasher with this genuine Midea 1800W heating element in pump body, part number 17476000007431. The heater sits around the circulation pump housing and warms the water as it is pumped to the spray arms, so detergent works properly and dishes come out clean and dry. It is listed for Midea-built dishwashers sold under the Kenwood, Logik, Caple and Currys Essentials names, and is usually replaced when the water stays cold, the machine trips the electrics or a heater error appears.

Product Details

• Product Type: Dishwasher heating element in pump body, 1800W
• Main Part Number / MPN: 17476000007431
• Alternative / Manufacturer References: 674001100084, 17476000005319
• Part Category: Heating elements
• Appliance Types: Dishwashers
• Brand Compatibility: For selected Kenwood, Logik, Caple and Currys Essentials models (Midea-built)
• Part Type: Genuine Original Part
• Pack Includes: 1 x genuine heating element in pump body

What This Part Does

In this design the heating element is built into the pump body rather than lying in the bottom of the tub. Water from the sump passes through the heated housing on its way to the spray arms, bringing it up to wash temperature quickly and evenly. If the element fails, the dishwasher may run but wash in cold water, stop with a heating fault, take far longer to finish or trip the household electrics.

Common Fault Symptoms

• Water stays cold during the wash
• Dishes left greasy or not dried
• Heater or temperature error code
• Programme takes much longer than usual or stalls
• Dishwasher trips the RCD or fuse when it starts to heat

Known Compatible Brands & Models

Repair Difficulty

Moderate to advanced: unplug the dishwasher, turn off the water and remove the plinth. Most models need the machine laid on its back or side to reach the pump from underneath. Release the hose clips, unplug the heater and pump connectors, then swap the heater pump body and refit everything exactly as it was. Allow around 45 to 90 minutes.

Typical Tools Required

• Cross-head screwdriver
• Pliers for the hose clips
• Towels and a shallow tray for residual water
• Phone camera to record the wiring

Description

Before ordering, compare your old part: this is an 1800W heater built into the pump housing. Check the model number on your dishwasher against the list.

This is a genuine Midea part, supplied new, pack of one.